Computer Operation Instructions - Spirit F8500 Instruction And User's Manual

10156

COMPUTER OPERATION INSTRUCTIONS

Getting Started:
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch
located at the front of the treadmill below the motor hood. Ensure that the safety key is installed, as
the treadmill will not power on without it.
When the power is turned on, all the lights on the display will light for a short time. Then the Time
and Distance windows will display Odometer readings for a short time. The Time window will
show how many hours the treadmill has been in use and the Distance window will show how
many kilometers (or miles if the treadmill is set to metric readings; see maintenance for changing
settings) the treadmill has gone. A message will be displayed showing the current software
version. The treadmill will then enter idle mode, which is the starting point for operation.
Quick-Start Operation:
STEP 1: Press and release any key to start the display (if not already on).
Note: Installing the tether key will also start the console.
STEP 2: Press and release the Start key to begin belt movement at 1.0 km (0.5 mph), then adjust
to the desired speed using the Fast / Slow keys (console or hand rail). You may also use the rapid
speed keys 2 through 12 to set to a specific speed directly.
STEP 3: To slow tread-belt press and hold the Slow key (console or hand rail) to the desired
speed. You may also press the rapid speed adjust keys, 2 through 12.
STEP 4: To stop the tread-belt press and release red Stop key.
page-13