Common Definitions, Terms And Phrases - Grizzly G1023SL Instruction Manual

Common Definitions, Terms and Phrases

The following is a list of common definitions, terms and phrases used throughout this manual as they relate
to this table saw and woodworking in general. Becoming familiar with these terms is important before
assembling, adjusting or operating this machine. Your safety is VERY important to us at Grizzly!
Arbor: Metal shaft extending from the drive
mechanism, to which cutting blade is attached.
Bevel Edge Cut: Tilting the saw arbor and blade
to an angle between 0° and 45° to perform an
angled cutting operation.
Blade Guard: Metal or plastic mechanism that
mounts over the saw blade to prevent acciden-
tal contact with the cutting edge.
Crosscut: Table saw operation in which the miter
gauge is used to cut across the grain of a piece
of wood.
Dado Blade: Blade or set of blades that attach to
the arbor and are used for cutting grooves and
rabbets.
Dado Cut: Table saw operation that uses a dado
blade to cut a flat bottomed groove into the
face of wood stock.
Featherboard: Safety device used to keep a
board against the rip fence or table. Allows
operator to keep hands away from the saw
blade.
Kerf: The resulting cut or gap made by a saw
blade.
Kickback: An event in which the wood is thrown
back toward an operator at a high rate of
speed.
Miter Gauge: A component that controls the
wood stock movement while performing a
crosscut. Allows for variation of angle cuts
such as miter cuts used on a picture frame.
Moulding Head: A cutterhead attached to the
arbor. Accepts interchangeable moulding
knives for profile cutting. We DO NOT recom-
mend the use of moulding heads because they
require advanced skills for their operation.
Parallel: Being an equal distance apart at every
point. i.e. the rip fence face is parallel to the
side face of the saw blade.
G1023SL/G1023SLX Left-Tilting 10'' Table Saw
Non-Through Cut: A sawing operation that
requires the removal of the blade guard and
splitter. Dado and rabbet cuts are considered
Non-Through Cuts because the blade does not
protrude above the top face of the wood stock.
Always remember to reinstall the blade guard
and splitter after performing a non-through cut.
Perpendicular: Intersecting and forming right
angles; at right angles to the vertical and hori-
zontal planes. i.e. the blade is perpendicular to
the table surface.
Push Paddle: Safety aid used to push a piece of
wood stock through a cutting operation.
Push Stick: Safety aid used to push a piece of
wood stock through a cutting operation.
Usually used when rip cutting.
Rabbet: Cutting operation that creates an L-
shaped channel along the edge of wood stock.
Splitter: Metal plate attached to the back of the
blade guard that maintains the kerf opening in
the wood when performing a cutting operation.
Standard Kerf: 1 ⁄ " gap made with a standard
8
blade.
Straightedge: A tool used to check the flatness,
parallelism, or consistency of a surface(s).
Through Cut: A sawing operation in which the
wood stock thickness is completely sawn
through. Proper blade height usually allows
of the top of the blade to extend above the
wood stock.
Thin Kerf: 3 ⁄ " gap made with a thin kerf blade.
32
Rip Cut: A cut made along the grain of the wood.
Sacrificial Fence: A piece of wood attached to
the face of the rip fence that is designed to
extend the fence face away from the metal por-
tion of the fence. Used primarily when making
rabbet cuts with a dado blade.
1
⁄ "
4
-7-