Selecting Time (Tijd Progr.); Selecting Delay Start (Startuitstel); Starting The Drying Programme - AEG Electrolux LAVATHERM 88800 User Manual

In certain programmes the spin speed has not effect (time controlled cycles), its
selection can be not selectable and only three dashes are visualized. Available se-
lections: from 800 to 1800 rpm's in 100 rpm's intervals.
The maximum value depends by selected program, the minimum is always 800 rpm
For those programs where the spin speed has no effect (time controlled cycles), the
selection is not allowed and three dashes "- - -" are displayed that has the meaning
of not set or unknown.
The user interface always remembers last spin selection, and proposes it as default
for all new selected programs. If memorized spin speed is greater than maximum
allowed value it will be automatically reduced to max spin speed available for the
selected program.

Selecting TIME (TIJD PROGR.)

To select the programme duration after setting the TIME programme. You can select
a programme duration from 10 minutes to 3 hours in 10-minute steps.
1. Turn the programme knob to the TIMED PROGRAMME. The 0:10 minutes is in
the display (corresponding to the COOLING programme).
2. Press the TIME button repeatedly until the desired programme duration is
shown in the display, e.g. 0:20 for a programme of 20 minutes.
If the programme duration is not selected, the duration is automatically set to 10
mins.

Selecting DELAY START (STARTUITSTEL)

See chapter Pro Steam system, section Selecting DELAY START (STARTUITSTEL).

Starting the drying programme

Press the START PAUSE (START PAZUZE) button. The programme starts.
The progress bar and the name of currently performed phase, above it, show stage
of the cycle.
With wet laundry, after a few minutes the appliance will show the correct pro-
gramme duration and foreseen time of cycle end.
It is normal for the appliance to make noises during drying programme if garments
with hard parts, such as metal buttons, are put in the drum.
33