Connections/System Wiring Diagram - Alpine EZi-DAB Owner's Manual

Connections and System Wiring
Diagram
A EZi-DAB power connector pins
Pin Function
1 Nav_Tel_Audio+
2 Nav_Phone_Mute
3 Cabin illumination
4 12V Permanent battery supply (with series fuse
holder)
5 Nav_Tel_Audio_GND
6 12V Switched ignition (with series fuse holder)
7 Car mute (with crimp)
8 Ground
ISO connector pins
B
Pin Function
1 Mute 1 (with crimp)
2 Mute 2 (with crimp)
3 Mute 3 (with crimp)
4 12V Switched ignition (with series fuse
5 Not used
6 Cabin illumination
7 12V Permanted battery supply (with series fuse
holder)*
8 Ground
18
Colour
Purple
Grey
Brown
Yellow
Pink
Red
Orange
Black
Colour
1 2
White
3 4
5 6
Orange
7 8
Blue
holder)* Red
2 1
4 3
Green 6 5
8 7
Brown
Yellow
* On some vehicles switched and permanent live connections may be reversed.
Black
Open the fuse holders and swap the connections round if required.
† If connected to Head Unit AUX IN then FM antenna connections to EZi-DAB are not required.
USB extension cable
5 6 7 8
(supplied)
1 2 3 4
Mute
Power loom
(supplied)
Head Unit AUX IN connection
Fuse holders for
cable (3.5mm to dual phono
permanent 12V and
or 3.5mm)
switched 12V.*
EZi-DAB controller bracket (supplied)
AUX IN cable
Existing vehicle FM
(3.5mm supplied)
antenna †
FM loop-through
†
cable (supplied)
†
Optional antenna (e.g. KAE-220DA)
or any active (powered) DAB antenna
Head Unit
with 5V phantom feed and SMB (f)
Please make sure ONLY to connect
a dedicated 5V phantom supplied
antenna. Failure to do so may result
in the device becoming defect.
connector