Simple Solutions; Handset/Base - Uniden DECT1825 Owner's Manual

Simple solutions

The most common problems often have the
simplest solutions.
We hope that you will not experience any problems
with your product, but in the event that you do, this
section hopes to overcome any problems quickly
and with minimum effort.
Firstly, check that:
• the telephone line cord is correctly connected.
• the mains power cord is correctly connected
and switched on.
• the battery pack is charged and not in need of
replacing.
If you have more than one handset registered to
your base remember to check the connections
on this too.
If you are still experiencing a problem, you are
likely to find a solution opposite.

Handset/Base

No dial tone
• Is the handset registered to the base?,
see page 28.
• Is the symbol flashing and can you hear a
beep during a call? – if so, move closer to the
base as you are out of range.
Cannot dial out
• Is symbol displayed, if so the keypad lock is
on, see page 16.
Handset does not ring
• The ringer volume may be set to off, see page
20.
• Is the symbol flashing? – if so, move closer
to the base as you are out of range.
[39]