How to Ride your Bike
Running IN
Proper running-in is important for the better life and
trouble free performance of the vehicle.
•
During first 2000 kms running-in period do not
exceed following speed limits.
Kms
1st
0 - 1000
14
1000 - 2000
19
•
Always keep the speed below the limits mentioned
in the table.
•
Do not race the engine excessively.
•
Do not start moving or race the engine immediately
after starting. Run the engine for a minute at idle
speed to give the oil a chance to workup into the
engine.
Riding the Bike
Before starting the vehicle and with the ignition key off,
adhere to the following first thing in the morning or after
a long period of non-use (whichever is the case).
Depress the clutch lever completely. Kick the kick lever
all the way down to its stop, briskly a couple of times.
Release the clutch lever.
2nd
3rd
4th
5th
22
31
38
45
31
43
52
62
Starting the Engine :
•
Keep the fuel tap to ON or RES position.
•
Turn ignition switch to ON position.
•
Turn Kill switch to (
•
Confirm that the vehicle (transmission) is in neutral.
•
Keep the throttle completely closed, push the starter
button (
) or kick the engine with kick starter lever.
CAUTION : Do not operate the starter continuously
for more than 5 sec. Wait for 15 sec. before you re-
start.
NOTE : The motorcycle is equipped with a starter
lockout switch. The vehicle can start in any gear when
clutch lever is depressed.
It is recommended to start the engine with the
transmission in neutral.
Moving Off :
•
Check that Center/Side stand is up.
•
Depress the clutch lever.
st
•
Shift into 1 gear.
•
Open the throttle and release the clutch lever slowly
and simultaneously.
•
As the clutch starts to engage, open the throttle a
little more, giving the engine just enough rpm to
keep it from stalling.
) ON position.
12