LG LVS301 Owner's Manual page 10

RESET button
e
Push the button more than 3 seconds, this would restore the factory default settings.
RS-485/RS-422 Dip Switch
f
The default position of the dip switch and function are as shown below.
VIDEO OUT
g
Supplies analog video signal (composite) to the connected device.
AUDIO OUT (Line Level Output)
h
Connect to an active speaker with a built-in amplifier.
AUDIO IN (Line Level Input)
i
Input for a mono microphone, or a line-in mono signal.
ETHERNET/POE Port
j
Connects to a PC or a network via a hub with a 10 BASE-T/100 BASE-TX cable attached RJ-45 connector.
Note:
Power over Ethernet (PoE) is a technology that integrates power into a standard LAN infrastructure. It enables power to be provided
to the network device, such as a network camera, using the same cable as that used for network connection. It eliminates the need
for power outlets at the device locations and enables easier application of uninterruptible power supplies (UPS).
Power input terminal
k
Connects to a DC 12 V or AC 24 V power supply using proper cables.
10
Position SW1
ON RS-485
OFF RS-422
SW2 SW3
RS-485 HALF
RS-485 FULL
SW4
TERMINATION ON
TERMINATION OFF
Introduction