Connectors; Hardware Overview - Axis Q1602 User Manual

Network camera

Hide thumbs Also See for Q1602:

Table of Contents

AXIS Q1602 Network Camera

Power LED

Network LED

Control button

Iris connector

Power connector

I/O terminal connector

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE). A shielded network cable (STP) must be

used to protect the product against power surges.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker

with a built-in ampliﬁer. A stereo connector must be used for the audio out.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For

instructions on how to insert and remove an SD card, please refer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup

> System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

•

Enabling the Focus Assistant. Press and very quickly release the Control button.

•

Connecting to an AXIS Video Hosting System service. See page 33. To connect, press and hold the button for about 1

second until the Status LED ﬂashes green.

Table of Contents

Q1602–e