After PIN credentials have been programmed, enter a PIN to operate the lock as follows:
Credential
Press a valid PIN
The "#" key is used as ENTER key for PINs with fewer than six digits.
If the PIN credential is entered incorrectly, press "
All error codes are indicated on the Schlage button by a solid red LED and a blinking green LED.
The number of green blinks indicates the error code.
Number of
Green Blinks
1
Computer programming error (not complete).
2
Too long user/master code entered. Code length cannot exceed 8 digits.
3
Memory full, too many codes. Delete some codes.
4
Master code cannot be deleted, only changed.
5
Master code entries do not match. Master code not changed.
6
Invalid command. Invalid function code entered.
7
Code not found.
Code too short. Minimum master code length is fi ve (5) digits, minimum user code
8
length is three (3) digits.
9
Not a unique code.
10
Manual programming not allowed.
If you encounter problems while performing any of the following tests, review the installation guide
and correct any problems.
Mechanical Testing
1. Rotate the inside lever or depress the push bar to open the door. Operation should be smooth,
and the latch should retract.
2. Insert the key into the keyway and rotate the key and the outside lever to open the door.
Operation should be smooth, and the latch should retract.
Electronic Testing
1. Press any number key. The lock will beep. Use the default PIN (13579 and "#") to verify access.
Error code functions have not been verifi ed by Underwriters Laboratories Inc.
USING THE LOCK
Green LED will blink and access granted
ERROR CODES
TESTING
CO-100 Offl ine Lock User Guide
Action
to start over.
"
*
Error Code Description
7