Page 1
BTU/HR @ 3.5” BTU/HR @ 3.5” BTU/HR @ 10” W.C. W.C. W.C. ME-10G, ME-15G 12,000 12000 12,000 FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
Page 2
SAFETY PRECAUTIONS FOR YOUR SAFETY, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE FOLLOWED AND ENFORCED. IF YOU SMELL GAS: • OPEN WINDOWS • DON’T TOUCH ELECTRICAL SWITCHES • EXTINGUISH OPEN FLAMES • IMMEDIATELY CALL YOUR GAS SUPPLIER 1. Instructions must be posted in a prominent location and all safety precautions taken in the event the user smells gas.
Page 3
Dimensions Water Shipping Wt. (inch) Model no. Capacity (lb.) (Gallons) ME-10G 10.0 50.0 ME-15G 15.0 55.0 INSTALLATION AND OPERATING INSTRUCTION: PRE-INSTALLATION INSTRUCTIONS: The installation of your water boiler must be made by a licensed plumber and the installation must conform with State and Local Codes or in absence of Local Codes, with the National Fuel Gas Code ANSI Z223.1 a latest version.
Page 5
PARTS LIST ME-10/15G DESCRIPTION ME-10G ME-15G KNOB M027A M027A COVER Q102H Q102H BODY R477A R478A GAUGE SHIELD MTG BRACKET U160A U160A VENT CAP ASSEMBLY X046A X046A GAUGE SHIELD WASHER KIT X012A X012A WATER GAUGE GLASS X043A X073A WATER GAUGE SHIELD...
Page 6
CLEARANCES: Your water boiler is design certified to use on combustible floors. The side and back clearances for combustible constructions are as follows: 6 inches from side and 8 inches from back. The water boiler must be installed with 4 inch high legs provided. GAS CONNECTION: Before connecting the water boiler to the gas line, check the rating label on the side panel to make sure that the gas type called for on the label coincides with the type of gas available on site.
Page 7
SHUTTING DOWN: For temporary shut down, turn the thermostat to lowest or OFF position; then turn gas cock dial to PILOT position. To shut boiler down completely, partially depress and turn gas cock dial to OFF position. MAINTENACE OR REPAIR: The owner should contact either the manufacturer or an approved local service company for maintenance or repair of the unit.
Page 8
BURNER REMOVAL: The burner can be removed with the unit standing in operating position. Turn off the gas flow to the unit. Allow the burner to cool off. Remove the wing nut holding the burner to the frame. Pull down the free burner end, enough to clear the threaded stud and pull the burner horizontally away from the manifold orifice.