Advertisement
Quick Links
OPERATION MANUAL
Contents
Specifications
Installation
Maintenance Tips
Repair Parts List
Wiring Diagrams
ELECTRICAL SPECIFICATIONS
VOLTS
MODEL No.
120
ME-10E
240
ME-15E
208
ME-30E
240
208
NOTE: FIELD WIRING MUST BE SUITABLE FOR 75 DEGREES CELCIUS.
USE COPPER WIRE ONLY FOR POWER SUPPLY CONNECTION.
COPPER WIRE: 14 AWG MINIMUM COPPER ONLY.
Every Cecilware product has been carefully inspected before shipment. The finest of materials and the highest
standards of workmanship have been but into the equipment.
Within 1 year of purchase, should any Cecilware product show defect in factory workmanship or material, we agree to
Repair, at our option or replace without cost to user such parts which prove upon factory inspection to have been so
defective. All equipment must be shipped transportation charges prepaid for acceptance. This warranty covers
replacement parts only, labor charges are covered for 90 days after installation.
This warranty does not apply under the following conditions:
• neglect or abuse of equipment
• excessive lime condition
• Improper installation
• any outside modification to equipment
Every Cecilware urn body is covered for three years. This warranty covers the stainless steel body and stainless steel
liners only.
Portable equipment such as Electric Fryers, Food Warmers, Electric Stoves, Dispensers, Plug-In Urns, Coffee
Brewers and Warmers must be returned to the factory or brought to an authorized service station for repair.
UNPACKING INSTRUCTION: Carefully unpack the water boiler and inspect immediately for
shipping damages. Your automatic water boiler was shipped in a carton designed to give maximum
protection in normal handling. It was thoroughly inspected before leaving the factory and the carrier
accepted and signed for it. File any claims for shipping damage or irregularities directly with the
carrier.
CECILWARE CORPORATION
43-05 20th AVENUE, LONG ISLAND CITY, N.Y. 11105 • 718-932-1414 • FAX 718-932-7860
AUTOMATIC
HOT WATER BOILER
MODEL No.
ME-10E
ME-15E
ME-30E
WATTS
AMPS
1,800
15.0
7,000
29.2
5,300
25.5
10,500
25.0
7,900
22.0
WARRANTY
FIELD
PHASE
WIRING SIZE
1
14AWG
1
10AWG
1
10AWG
3
10AWG
3
10AWG
N796A-10/98
Advertisement
Related Manuals for Cecilware ME-10E
Summary of Contents for Cecilware ME-10E
- Page 1 Within 1 year of purchase, should any Cecilware product show defect in factory workmanship or material, we agree to Repair, at our option or replace without cost to user such parts which prove upon factory inspection to have been so defective.
-
Page 2: General Specifications
(35). Place the vent cap (30) into the recess in the top of the unit. Mount the faucet assembly onto the shank (13). GENERAL SPECIFICATIONS DIMENSIONS (INCH) WATER CAP. IN SHIPP. MODEL NO. GALLONS WT.(LB) ME-10E 10.0 22.5 25.5 ME-15E 15.0 27.5 30.5 ME-30E 30.0... - Page 3 CECILWARE CORPORATION INSTALLATION INSTRUCTION FOR WATER BOILERS Water boilers are shipped with the thermostats in the OFF position. Do not turn the thermostat on before filling the water boiler with water. NOTE: When positioning the unit, leave a minimum of 6" clearance on the right side of the water boiler for ease of service.
- Page 4 SERVICE PROCEDURES FOR QUALIFIED SERVICE PERSONNEL ONLY TO REPLACE HEATING ELEMENT 1. Shut off electrical power to unit. 2. Shut off water supply to unit. 3. Drain water from unit by tilting the unit toward at the end of the drain cycle. 4.
- Page 5 TROUBLE SHOOTING PROCEDURES FOR QUALIFIED SERVICE PERSONNEL ONLY PROBLEM POSSIBLE CAUSES SOLUTIONS OR REMEDIES Line Fuse Check for circuit overload before resetting breaker or replacing fuse. Water fails to heat Circuit Breaker Hi-Limit Switch If Hi-Limit switch opens when water temp. reaches 200 degree F, replace switch.
-
Page 6: Wiring Diagrams
ME 10E / 15E WATER BOILER Schematic Wiring diagrams Electrical data diagrams ME10E/15E 208/240 V/3 phase VOLTS: 208/240 50/60 HZ WATTS: 7900/10500 AMPS: 22/25 PHASE: 3 ME10E/15E 120V 208/240 V/1 phase VOLTS: 208/240 50/60 HZ WATTS: 5300/7000 AMPS: 25.5/29.2 PHASE: 1 120 Volt Hook Up VOLTS: 120 50/60 HZ... - Page 7 J11.1 ME 10/15 E WATER BOILER PARTS ILLUSTRATION...
-
Page 8: Electrical Data
AMPS: 14.6 PHASE: 1 CONVERSION INSTRUCTIONS FOR ME-10E and ME-15E WATER BOILERS Conversion from 208 volts or 240 volts to 120 volts To convert to 120 volt 15 amp outlet application simply connect a 120 volt 15 amp line cord equipped with 2 prong grounding cap to terminal as follows.