Tires And Wheels - X-TREME X-250 User Manual

TIRE AND WHEELS
The X-Treme X-250 DOES NOT use an identical rim and tire assembly on the
front and rear wheels. The wheels are two wheel halves (split rim) bolted
together to make it easier to remove and replace the tire and tube. Tires can
easily be rotated between front and back wheels.
Tire wear will differ based on rider weight, riding conditions and care.
Replacement tires can be obtained at your local X-Treme dealer, through
motorcycle shops, or from the X-Treme website at www.x-tremescooters.com
Tire Pressure
The tire must be inflated to a maximum of 32 P.S.I. It is also recommended to
use a tube additive like Slime®, available from any motorcycle shop, to avoid
inconvenient punctures.
Empty all air from the tire, prior to loosening the bolt to split the rim.
To adjust the rear brakes:
For brakes that are adjusted too tight:
1. Loosen the tension screw on the
left hand brake lever by rotating it
counter-clockwise until the wheel
spins freely. (Fig. 7)
For brakes that are adjusted too loose:
1. Tighten the tension screw on the
left hand brake lever by rotating it
clockwise until the wheel has a
slight drag. (Fig. 7)
For further adjustment, Locate the
adjustment screw on the rear brake hub
located on the rear wheel.
For brakes that are adjusted too tight:
1. Loosen the tension screw on the
rear brake hub by rotating it
clockwise until the wheel spins
freely. (Fig. 8)
For brakes that are adjusted too loose:
1. Tighten the tension screw on the
rear brake hub by rotating it
counter-clockwise until the wheel
has a slight drag. (Fig. 8)
Page12