Denon AVR-E300 Owner's Manual page 26

Measurement (2nd – 6th)
• In this step, you will perform measurements at multiple positions
(one to five additional positions) other than the main listening
position.
• Just one listening position can be measured if you so choose, but
measuring multiple positions increases the accuracy of the correction
of acoustic distortion within the listening area.
9
Move the Setup and
measurement microphone to
position 2, select "Continue",
ENTER
and then press .
The measurement of the second
position starts. Measurements can be
made in up to six positions.
Audyssey Setup
P lace the micr oph one at e ar le vel a t th e 2 nd
L isten i n g pos it ion.
Continue
Calculation
Back
Audyssey Setup
P lace the micr o ph one at e ar le vel a t t he 3r d
L isten i n g pos it ion.
Continue
Calculation
Repeat Last Test
• To skip measuring the second and subsequent listening position,
i ENTER
use to select "Calculation" and press
12.
• To measure the second position again, use
ENTER
Last Test" and press .
DVD
10
Repeat step 9, measuring positions 3 to 6.
When measurement
"Measurements Complete." message is displayed.
M e a su re me n t s C o mp le t e .
to proceed to step
i
to select "Repeat
of position 6 is completed,
Audyssey Setup
Calculation
Repeat Last Test
23
Set up speakers (Audyssey® Setup)
Calculation
11
Select "Calculation" and then press
a
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Setup
Calibrat io n co mplete ! N ow Calc ulat ing ...
Pleas e wait ...
75%
• Analysis takes several minutes to complete. The more speakers
and measurement positions that there are, the more time it takes
to perform the analysis.
ENTER
.
v See overleaf