Grizzly G0459 Owner's Manual page 38

11. Mark the top of the table lift screws with
arrows (all pointing in same direction) and
mark the screws with liquid correction fluid
above the mounting bracket (Figure 45).
Later, when you reassemble the conveyor
table, you can use these marks to reset the
table height close to the current position.
Figure 45. Locations to mark table lift screws.
12. Mark the chain and sprockets with correction
fluid.
13. Loosen the idler roller sprocket (Figure 38),
carefully pull the chain off of all the sprockets,
and remove it from the cabinet.
14. Loosen the conveyor belt at the front adjust-
ments, as shown in Figure 46.
Figure 46. Conveyor belt loosened at the front
adjustments (only one shown).
-36-
15. Disconnect the conveyor feed motor wires
from the circuit board.
16. Remove the scale pointer.
Before removing the table, note the number and
location of brass shims (Figure 47) under the
table lift screws. Knowing their correct position
will help you align the conveyor table during reas-
sembly.
NEW
PHOTO
17. With the help of an assistant, carefully lift
the table off of the drum sander cabinet, as
shown in Figure 48.
Figure 48. Lifting the table off of the drum
Brass
Shims
Figure 47. Brass shims.
sander cabinet with two people.
G0459 12" Drum Sander