Table of Contents
Advertisement
1
Sensor-in / Alarm-out
The sensor terminal block is used to connect a sensor such as PIR to the SDDVR. If you add motion
sensor devices to your SDDVR, the video recording can be triggered by event.
The alarm output terminal is used to install a single alarm device.
2
SD Memory Slot
Insert SD Card into the slot for storing data.
3
Recording LED
This light indicates while SDDVR is on recording mode.
4
Status LED
This light blinks when events occur or there is any error..
5
Power LED
This light indicates the SDDVR is powered up.
6
Remote control Receiver
When controlling SDDVR by remote control, be sure to point at the receiver.
7
Reset
Press the reset button if you want to return setting values to the default.
8
AV-IN
Connect AV-IN connector
9
AV-OUT
Connect AV-OUT connector
10
Power
Connect 12V power supply in the package.
7
Advertisement
Table of Contents
