Genie CCTV SDDVR Installation & User Manual page 2

The SDDVR is manufactured to meet international safety standards.
precautions to avoid injury and prevent damage to the SDDVR or any products connected to it.
1. Use a correct power source. Do not connect this product to a power source that supplies more
than the specified voltage (DC12V), as this will cause damage to the unit.
2. Never insert anything metallic into the SDDVR as this can cause electric shock.
3. Do not operate in wet & dusty conditions. Keep product surfaces clean and dry. Avoid placing
the SDDVR in areas like a damp basement or a dusty hallway.
4. Do not expose this product to rain or use near water. If the product gets wet, unplug it and
contact an authorized dealer immediately.
5. To clean the outside case of the SDDVR, use a lightly dampened cloth (no solvents).
6. Do not operate if you suspected to unit is faulty. If there are any unusual sounds or smells coming
from the SDDVR, immediately unplug it and contact an authorized dealer or service centre.
7. Do not attempt to remove the top cover.
8. Warning: Removing the SDDVR 's cover can cause an electrical shock.
9. Handle SDDVR carefully to avoid damaging the product. Dropping your SDDVR on any hard
surface may cause the unit to malfunction. If the SDDVR does not work properly due to physical
damage, contact an authorized dealer for repair or exchange.
10. The unit has a lithium battery preinstalled.
The standard lithium cell 3V battery located on the motherboard should be replaced if the time clock
does not hold its time after the power is turned off.
Warning:
Unplug the SDDVR before replacing battery or you may be subjected to severe electrical shock.
Properly dispose of old batteries.
Caution:
Risk of explosion if battery is replaced by an incorrect type. Do not discard lithium batteries into the
trash can or into fire. Dispose in accordance with local waste regulations.
Information to user
The user's manual or instruction manual for an intentional or unintentional radiator shall caution the user
that changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
GENERAL SAFETY AND PRECAUTIONS
Read the following safety
2