Battery Replacement - SkyLink IQ SERIES Owner's Manual

Remote Control
To activate the opener with remote control, hold down the
button until the door starts to move. When the button is
press, the light indicator on the remote will flash. For remote
with multiple buttons, ensure to press the button that is
programmed to the desired opener.

Battery Replacement

All remotes come with battery installed. To replace the battery,
follow the instructions below.
Wall Button
Press the push button on the wall console to activate the
garage door opener.
On the Wall Console, there are additional features:
Event log
The log will show you the time for the last 10 opener's
operation. To check the log:
Press the "Display" button on the Wall Console, the display
will show:
1) Time of opener's activation
2) Door Open or Door Close
3) Number of days ago when this happened (up to 9 days,
operations more than 9 days ago will not be stored)
:
Press the display again will show another event. The Wall
Console can store up to 10 events.
OPERATION
12 volt alkaline battery
(size 23A) included.
12 volt alkaline battery (size 23A)
(included).
It is time to change the battery when
the red LED on the transmitter does
not turn on when either button is
pressed.
WARNING WARNING
To prevent possible serious injury or death:
- Never allow small children near batteries
- If battery is swallowed, immediately notify doctor.
Lock Button
The Lock Feature can be used to disable all remote controls
from operating the garage door opener. There are 2 types of
lock:
1) Manual Lock - Manually enabling this lock will disable all
remote controls from operating the garage door opener.
You must unlock it manually if you wish to allow
operation of the remote controls again.
Programming
Display
Enable / Disable
Lock Timer /
Manually Lock
Light On / Off
-24-
Visor Clip - Install the visor clip
to the remote as shown.
:
Open / Close
Door
(Push button)