Route & Secure The Sensor Wires - SkyLink IQ SERIES Owner's Manual

1 3
Mounting the Sensor on the Wall
(Optional)
For wall mounting, use wood block to increase the
depth and have enough clearance for the sensor
beam to be unobstructed.
5 1
Route & Secure the Sensor Wires
Run the wires up the wall, then over to the center
of the door. Secure the wires to the wall with wire
holders. Run the wires along the top of the T-rail
and secure them with 4 wire clips provided.
1 6
Connect the Wires to the Opener
Twist like colored wires together. Connect the wires to the "Safety Sensor" terminals.
Wires are not polarity sensitivity (either wire to either terminals)
Actual Size
C5
INSTALL SAFETY BEAM SENSOR
Wood Block
C2
4 1
Mounting the Sensor on the Floor
(Optional)
For floor mounting, use wood block to elevate the sensor
brackets if necessary. Ensure the sensor is no higher than
6" (15cm) above floor. Fasten the screws to the floor with
concrete anchors (Not Provided).
Lag screws
C5x2
Red
C3
-17-
Attach with concrete anchors
(Not provided)
Lag screws
C5x2
Wire Clip
C2
Wire Holder
C3x1
White