Attach The Header Bracket; Position The Opener; Connect The T-Rail To The Header Bracket - SkyLink IQ SERIES Owner's Manual

Attach the Header Bracket

1 4
Place the bottom edge of the bracket on the line marked
above the highest point of travel.
1-1/4" Above (Sectional Door)
7" Above (Jamb Door)
Highest Point
of Travel
Note the orientation of the header bracket, do not mount it upside down.

Position the opener

5
Position the opener on the floor with
packaging material as protective base.
Actual Size
B1
INSTALL THE HEADER BRACKET
Mark the 2 holes
with a pencil.
Position the pulley bracket
against the header bracket
B6
Drill Two 3/16"
Pilot Hole
Ceiling Installation
The header bracket may be mounted to the ceiling if there is
minimal clearance above the door. If so, extend the centerline
to the ceiling. The back edge of the bracket must not be further
than 5" from the header wall.

Connect the T-Rail to the Header Bracket

6
B5x1
Align the bracket holes and join
with a clevis pin and hitch pin
as shown
-9-
Attach the header
bracket with 2 lag
screws provided
B6x1
B5
B1x2