Signal Check - Hitachi CLE-971 User Manual

OTHER FUNCTIONS (continued)
Signal Check (Analog RGB mode)
Changes in the signal status are displayed on the screen as they arise.
Status
A guide is displayed for the
When Mode Display is set to
input terminal and the
ON, the input signal is
switched or when the horizontal and vertical sync
RECALL button is pressed. frequency.
When the sync signal is no • A guide displays No Input
longer detected. Signal, and Power Save
(for approx. 5 sec.)
• When the condition
continues where the sync
signal cannot be detected,
indicator lamp of power
source changes in orange
and the mode switches to
power save mode.
When the input signal does A guide displays No Input
not match the monitor Signal.
specifications or is in an
unstable status.
Signal Check (TV/Video mode)
Changes in the signal status are displayed on the screen as they arise.
Mode Status
TV When the TV signal • A guide is displayed for
is no longer searching and counting down
detected. 2 minutes.
• If the TV signal cannot be
detected after 2 minutes, the
PDP TV will turn off directly
and indicator lamp is going to
red.
Video When the sync. • A guide displays No Sync.
signal is no longer Signal in orange.
detected.
Display Action
Recheck the personal
computer power switch
status and the
connection status.
Recheck the input
signal specifications.
Display Action
• Recheck the antenna
connection status.
• Reception other than
those of broadcasting
stations can be
considered.
• Recheck the device
power switch status
and the connection
status.
• Recheck the device
connection status.
• Recheck the input
signal specifications.
Analog RGB
1024X768 60Hz
No Input Signal
Going to suspend
(Going to standby)
No Input Signal
Going to sleep
2 : 0 0
No Input Signal
Searching
(Video source name)
No Sync. Signal
35