Input Switching To Tv/Av1~5,Hdmi, And Rgb; Input Signal Screen Display - Hitachi 55PD9700C User Manual

BASIC OPERATION (continued)
Input Switching to TV/AV1~5, HDMI, and RGB
By pressing Input Select button, you can switch the input.
To watch actual broadcast, press Input Select button on the control panel,
the numeric buttons or Channel Up/Down button on the remote control.
To display the image outputting from the external equipments
connected to each terminal (DTT / TV, AV1~5, HDMI 1 / 2, and RGB),
select corresponding mode.
1. Press Input Select buttons on the remote control.
2. The Input modes can be also switched by using Input Select button
on the control panel.
Each time this button is pressed, the screen displays corresponding
mode by following order.
DTT TV
RGB HDMI 2
3. To directly go back to TV mode, pressing channel Up/Down buttons on
either remote control or the control panel.
Also, you can use the numeric buttons on the remote control.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the
the remote control.
The display in DTT mode will also appear as changing the channels and go out in
approximately 3 seconds. Refer to
The display in TV/Video/RGB mode will go out in approximately 6 seconds.
DTT
Programme
Now: ----
Next: ----
name
1. ABCDE
Channel
name
TV
Off-timer
-- -- Min.
OFF
-- -- : -- --
On-timer
VIDEO
Off-timer
-- -- Min.
OFF
-- -- : -- --
On-timer
RGB
Off-timer
-- -- Min.
OFF
On-timer -- -- : -- --
AV1 AV2 AV3
HDMI 1 AV5 AV4
44
about the information banner.
-- -- : -- -- - -- -- : -- --
Broadcasting time
-- -- : -- -- - -- -- : -- --
Signal Level:
-- : --
TV position
1
ABCDE
Name
Sound mode
Input mode
AV1
Composite
Signal mode
Input mode
RGB
Input horizontal frequency
H : 48.4kHz
V : 60.1 Hz
Input vertical frequency
Input Select buttons
SD MEMORY
CARD
Channel Up button
PUSH-EJECT
P
P
Channel Down button
OK
Input Select button
PH35814
button of
+
Channel
Up/Down button
Recall
button
23