Table of Contents
Advertisement
FILE LOCATION: E:\workarea\customer\MAXNET\061101_ML-3731Manual-revisions\ch5e.fm
TV Menu Messages
While using your TV, the following messages may appear.
Message
Auto Adjust
Out of Range
No Video Input
TV Buttons Locked
In Power Save Mode
Press any key on keyboard
or move mouse
Self Test
Remote Control Problems
Problem
The TV does not respond when
using the remote control
DELL CONFIDENTIAL – PRELIMINARY 12/6/06 – FOR PROOF ONLY
35
Troubleshooting Problems With Your TV
Possible Solution
No action required, the TV is performing an auto adjustment.
Check the resoluton settings on your PC to a standard VESA
supported resolution of 1024x768.
Check all cables are properly connected.
1
Ensure the proper source is selected. See "Input Select" on
2
page 26 for more information.
To unlock, press Menu on your remote control, select Setup.
If you have a computer connected to the TV display and there
is no signal detected, the TV display goes in to sleep mode.
The power light is amber when the TV display is in sleep mode.
Appears for computer source when there is nothing plugged in.
Select VGA from Input Select menu and nothing is plugged in.
Plug a computer in to the VGA connector.
Possible Solution
Point the remote control directly at the lower right corner of the
1
TV display. Be sure that nothing is blocking the front of the TV
display. For the location of the IR, see "Front View" on page 5.
Press the TV button on the remote control to set the remote to
2
function for TV instead of other devices available on the
Univeral Remote.
Verify that the batteries are properly installed.
3
If the batteries are old, install new batteries.
4
NOTE:
Bright lights or other infrared devices may interfere
with your remote control and IR on the TV display.
Advertisement
Table of Contents
