Installation Precautions - Majestic fireplaces DV580 Homeowner's Installation And Operating Manual

Burner Pan
Shutter
Retaining
Screw
Air
Shutter
Front View
CO103
Fig. 71 Remove air shutter from burner pan.
Gas Conversion
6. Re-install manifold to burner pan.
Air shutter
2/15/99 djt
Pilot Orifice Conversion
NOTE: It is not necessary to remove the pilot tube for
conversion.
1. Remove pilot hood by lifting up. (Fig. 72)
2. Remove pilot orifice with Allen wrench. (Fig. 73)
3. Install conversion pilot orifice.
4. Re-install pilot hood and be sure to align with index
tab. Installation is complete.
Pilot Hood
Pilot
Bracket
Fig. 72 Remove pilot hood.
Index Tab
Snap Ring
Fig. 73 Remove pilot orifice.
Fuel Conversion Instructions
Honeywell Comfort Control Valve ONLY
CO106a
DV360/580
WARNING: The conversion must only be
Gas Conversion
undertaken by a qualified, certified gas ap-
Pilot2
pliance installer.
1/28/00 djt

Installation Precautions

Before proceeding, turn control knob on valve to OFF
and turn gas supply OFF. Turn OFF any electricity that
may be going to the appliance. CAUTION: Logs may
be hot!
Conversion Procedure
1. Open bottom grille to gain access to valve. Remove
glass door. (Refer to "Window Frame Assembly Re-
20010667
CO103
CO105a
Allen Wrench
CO105a
DV360/580
Gas Conversion
Pilot
1/28/00 djt
CO106a
DV360/580 Series Direct Vent Gas Fireplace
moval Section" Page 24, Fig. 47)
2. Remove logs if previously installed. CAUTION: Logs
may be hot!
3. Remove and replace plug on lower right hand side of
the valve; Red for LP and blue for NG. (Fig. 74)
4. Remove motor top cap. Depress and turn center
plunger until arrow points to correct screw. Red for
LP and Blue for NG. NOTE: Plunger will "snap" into
NG position when arrow is close to blue screw. It will
not "snap" at LP (Red) position. (Fig. 75)
Motor Top Cap
Local/
Pilotstat
Remote Switch
Knob
Fig. 74 Comfort control valve.
FP1037
Honeywell
Center
comfort valve
Plunger
3/22/00 djt
Blue - NG
Red - LP
Fig. 75 Depress and turn center plunger.
Burner Orifice Conversion
DV360
1. Remove the screws that secure the fettle and the
burner tube assembly, located behind the burner
tube assembly. Remove the two (2) screws that
secure the burner housing assembly to the base pan
at the right end of the burner housing assembly. (Fig.
66)
2. Remove the fettle and the burner tube assembly.
Slide the burner housing assembly to the right and
up to free the orifice.
3. Using a 1/2" open end wrench remove the orifices.
(Fig. 67)
4. Converting LP to NG, remove bracket/gasket as-
sembly by unfastening the screw which secures the
bracket to the burner tray base. Discard bracket and
refasten the screw into the hole. (Fig. 67a)
Converting NG to LP, assemble the bracket/gas-
ket assembly to the burner tray assembly base by
Piezo Ignitor
OFF
•
LED
Plug
Antenna
FP1037
Motor Top Cap
OFF
•
FP1037b
FP1037b
comfort valve
convert
3/6/01 djt
43