Mounting Back Plate; Mounting Pick Guard - Grizzly H3123 Instruction Manual

Mounting Pick
Guard
To secure the pick guard to the guitar body:
Position the pick guard so the 1st string is
1.
centered over the corresponding round metal
pick-up peg as shown in Figure 30.
Figure 30. Pick guard mounting location.
Secure the position of the pick guard to the
2.
guitar body with masking tape.
3
3. Using a ⁄ " drill bit, drill
32
straight through the eleven holes in the pick
guard. Note—Drilling the holes deeper than
1 ⁄ " could result in drilling out through the
2
back of the guitar body.
Secure the pick guard to the guitar body with
4.
the included eleven
-18-
1
⁄ " deep holes
2
1
⁄ " wood screws.
2

Mounting Back Plate

Once mounted, the six holes in the back plate
need to align with the six holes in the tremolo
bridge. This will simplify the string installation and
removal process.
To mount the back plate to the guitar body:
Position the back plate over the cavity in the
1.
back of the guitar body as shown in Figure
31.
Figure 31. Mounting the back plate.
Secure the position of the back plate to the
2.
guitar body with masking tape.
Using a 3 ⁄ " drill bit, drill
3.
32
straight through the six holes in the back
plate. Note—Drilling the holes deeper than
1 ⁄ " could result in drilling out through the front
2
of the guitar body.
Secure the back plate to the guitar body with
4.
the included six 1
1 ⁄ " deep holes
2
⁄ " wood screws.
2
H3123 Electric Guitar Kit