Pick Guard - Grizzly H3123 Instruction Manual

5
4. Using a ⁄ " drill bit, drill 1
32
straight through the four holes in the back of
the body (Figure 13). Note—Drilling the
holes deeper than 1
out through the fingerboard.
Figure 13. Drilling the screw holes.
Place the black neckplate setter and the sil-
5.
ver neckplate over the holes on the back of
the guitar body.
6. Secure the neckplate assembly, the guitar
body, and the neck together with the includ-
3
ed 1 ⁄ " wood screws (Figure 14). DO NOT
4
use glue.
Figure 14. Correctly attached neck.
-12-
3
⁄ " deep holes
4
3 ⁄ " could result in drilling
4

Pick Guard

To attach the pick guard to the guitar body:
Push one white and one black wire through
1.
the hole shown in Figure 15.
Figure 15. Pick guard wires.
2. Push the remaining black wire through the
hole shown in Figure 16.
Figure 16. Pick guard wire.
H3123 Electric Guitar Kit