Audio Jack; Winding Strings - Grizzly H3123 Instruction Manual

Audio Jack

To attach the audio jack to the guitar body:
1. Solder the wires shown in Figure 26 to the
tabs on the audio jack.
Figure 26. Soldered audio wire.
Turn the audio jack over and insert it in the
2.
cavity on the guitar body.
Secure the position of the audio jack to the
3.
guitar body with masking tape.
Using a 3 ⁄ " drill bit, drill
4.
32
straight through the two holes in the audio
jack. Note—Drilling the holes deeper than
could result in drilling out through the back of
the guitar body.
Secure the audio jack to the guitar body with
5.
the included two
-16-
1 ⁄ " deep holes
2
1 ⁄ " wood screws.
2

Winding Strings

The correct position of the guitar strings is shown
in Figure 27. The thin High E string is called the
"1st" string and the thick Low E string is called the
"6th" string.
Figure 27. Correct string locations.
To install the guitar strings:
Slide the 1st guitar string through the corre-
1.
sponding hole in the back plate (Figure 28).
1
⁄ "
2
Figure 28. 1st string installation hole.
6
E
5 A
4 D D
3
G
2 B
1
E
H3123 Electric Guitar Kit