Grizzly H3123 Instruction Manual page 16

Attach pieces of sewing thread to the 1st and
3.
the 6th machine head and tape the opposite
ends to the edges of the tremolo bridge.
Adjust the tremolo bridge so there is an
4.
equal amount of space between the finger-
board edges and the threads (Figure 20).
Attach Threads Here
Equal Space
Figure 20. Checking neck alignment with
tremolo bridge.
When all adjustments are correct, secure the
5.
position of the tremolo bridge to the guitar
body with masking tape.
3
6. Using a ⁄ " drill bit, drill
32
straight through the six holes in the tremolo
bridge (Figure 21). Note—Drilling the holes
deeper than 1 ⁄ " could result in drilling out
2
through the back of the guitar body.
Figure 21. Drilling the bridge mounting holes.
-14-
Attach Threads Here
1
⁄ " deep holes
2
Secure the tremolo bridge to the guitar body
7.
with the included six
8. Flip the guitar body over and place the spring
hanger in the cavity as shown in Figure 22.
Figure 22. Spring hanger placement.
Secure the position of the spring hanger to
9.
the guitar body with masking tape.
10. Using a 1 ⁄ " drill bit, drill 1
8
straight through the two holes in the spring
hanger (Figure 23). Note—DO NOT drill the
holes deeper than 1
Figure 23. Drilling the spring hanger
mounting holes.
1
⁄ " wood screws.
2
1 ⁄ " deep holes
2
1 ⁄ ".
2
H3123 Electric Guitar Kit