Start Protection / Child Lock; Pause Or Stop Cooking - Whirlpool JT 359 Instructions For Use Manual

START PROTECTION / CHILD LOCK

This automatic safety function is
activated one minute after the oven has
returned to "stand by mode". (The oven is in
"stand by" when the 24-hour Clock is
displayed, or if the Clock has not been set,
when the display is blank).
To pause cooking:
The cooking can be paused
to check, turn or stir the
food by opening the door.
The setting will be
maintained for 10 minutes.
To continue cooking:
Close the door and press the Start
button ONCE. The cooking is
resumed from where it was paused.
Pressing the Start button TWICE will
increase the time by 30 seconds.
1
3
5
1. Press the Clock button (3 seconds) until
the left-hand digit (hour's) flicker.
2. Press the +/- buttons to set the hours.
3. Press the Clock button again. (The two
right hand digits (minutes) flicker).
4. Press the +/- buttons to set the minutes.
5. Press the Clock button again.
The Clock is set and in operation.
6
The door must be opened and closed
e.g. putting food into it, before the safety
lock is released. Else the display will show
"door".

PAUSE OR STOP COOKING

If you don't want to continue
cooking:
Remove the food, close the door
and press the STOP button
A beep will signal once a minute
for 10 minutes when the cooking is
finished. Press the STOP button or open
the door to cancel the signal.
Note: The oven will only hold the settings
for 60 seconds if the door is opened and
then closed after the cooking is finished.
CLOCK
2
4
Note: When the appliance is first plugged in
or after a power failure, the display is blank.
If the clock is not set, the display will remain
blank until the cooking time is set.
If you wish to remove the clock from the
display once it has been set. Simply press
the Clock button (3 seconds) until the left-
hand digit (hour's) flicker. Then press the
Stop button.
To reinstate the clock, follow the above
procedure.
Clock timeout: each step must be
accomplished within 60 seconds. Else,
the display will return to stand by mode
automatically.