Installation; Prior To Connecting; After Connecting - Whirlpool JT 359 Instructions For Use Manual

PRIOR TO CONNECTING

Check that the voltage on the rating plate
corresponds to the voltage in your home.
Place the oven on a stable, even
surface that is strong
enough to hold the oven
and the food utensils
you put in it. The right
side of the unit is the
heavy side. Use care when handling.
Position the oven at a distance from other
heating sources. The cooling air, which is
taken in by the oven, must not exceed 35°C
temperature. For sufficient ventilation there
must be a space of at least 15-cm above
the oven. Ensure the microwave oven feet
are in place and ensure the space
underneath the oven is empty to allow for
proper airflow. The oven can operate in an
ambient temperature ranging from +5°C to
+35°C.

AFTER CONNECTING

When the appliance is first plugged in or
after a power failure, the display is blank. If
required, the oven can display a 24-hour
digital Clock. When the Clock function is not
programmed the display will remain blank
until the cooking time or the Timer is set.
The oven can be operated only if the oven
door is firmly closed.
Poor television
reception and radio
interference may
result if the oven is located close
to a TV, radio or aerial.
2

INSTALLATION

This oven is not intended to be placed or
used on a working surface lower than 850
mm above the floor.
For best visibility of the display, place the
oven such that the display is below or equal
in height to your eyes when standing in front
of it.
Do not remove the microwave inlet
protection plates located on the side of the
oven cavity wall. They prevent grease &
food particles from entering the microwave
inlet channels.
Ensure that the appliance is not
damaged. Check that the oven door closes
firmly against the door support and that the
internal door seal is not damaged. Empty
the oven and clean the interior with a soft,
damp cloth.
Do not operate this appliance if it has a
damaged mains cord or plug, if it is not
working properly, or if it has been damaged
or dropped. Do not immerse the mains cord
or plug in water. Keep the cord away from
hot surfaces. Electrical shock, fire or other
hazards may result.
The earthing of this appliance is
compulsory. The manufacturer will accept
no responsibility for injury to persons,
animals or damage to objects arising from
the non-observance of this requirement.
The manufacturers are not liable for any
problems caused by the user's failure to
observe these instructions.