Table of Contents
Advertisement
20
STARTING COLD ENGINE
WARNING
When engine is started, confi rm that there is not any abnormal
vibration or sound. If there is abnormal vibration or sound, ask
your DEALER to repair. After refueling tighten fuel cap fi rmly and
check for leakage. In case of fuel leakage repair before starting
operation since there is a danger of fi re.
WARNING
Th e attachment will operate immediately when the engine starts,
and could result in possible serious injury. Keep movable parts of
the attachment away from objects that could become entangled or
thrown, and surfaces that could cause loss of control.
1. Stop Switch
Move stop switch (A) forward away from the STOP position.
2. Choke
Move choke lever (B) to Cold Start Position (
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and fl ows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4.
Press the decompression device (E).
5.
Recoil Starter
Lay the unit on a fl at area and keep movable attachment parts clear
of all obstacles. Hold unit fi rmly, and rapidly pull recoil starter
handle/rope (D) until engine fi res (or maximum fi ve [5] pulls).
6.
Choke
After engine fi res (or 5 pulls), move choke lever back to Run
(
) position. Pull recoil starter starter handle/rope until engine
starts and runs. Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in "Run" position after 5 pulls,
repeat instructions 2 - 5.
7.
Throttle Trigger
After engine warm-up, gradually depress throttle trigger to increase
engine RPM to operating speed.
).
A
B
D
C
E
D
Advertisement
Table of Contents
