Table of Contents
Advertisement
6.
Secure the right hand U-handle by tightening 4 right handle assem-
bling bolts (H) loosely.
7.
Adjust handles for comfortable operation and tighten handle as-
sembling bolt (E) and 4 right handle assembling bolts (H).
8.
Route throttle linkage and ignition lead assembly along shaft and
clip as shown.
BALANCE AND ADJUST UNIT
1.
Loosen harness clamp screw.
2.
Put on harness and attach unit to harness.
3.
Slide harness clamp up (A) or down until unit balances with head
approximately 50-75 mm (2 -3 in.) from the ground.
4.
Tighten harness clamp screw.
5.
Loosen upper U-Handle clamp screws (B), and position U-Handle
for comfortable operation.
6.
Tighten U-Handle clamp screws and 8 mm clamp bolt securely.
G
T
RASS
RIMMER
O
PERATOR
A
/B
C
RUSH
UTTER
'
M
S
ANUAL
H
E
B
13
Advertisement
Table of Contents
