Table of Contents
Advertisement
COOLING SYSTEM
Level 2.
Tools required:
Air compressor and safety nozzle, or: 4 mm Hex
wrench, 25 - 50 mm (1 - 2 in.) cleaning brush.
Parts Required: None.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fi n area. This fl ow of air carries
combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and debris build-up on the outside of the cylinder. This build-up
insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages and cleaning of cooling fi ns is
considered "Normal Maintenance." Any failure attributed to lack of
maintenance is not warranted.
1. Periodically blow dirt and debris off cooling fi ns with a compres-
sor and safety nozzle, or;
2.
Remove engine and muffl er covers, and brush off dirt and debris
using the medium bristle brush.
EXHAUST SYSTEM
Spark Arrestor Screen
Level 2.
Tools Required: Cross Head Screwdriver, Soft Metal Brush, 4 mm
Hex Wrench
Parts Required: Spark Arrestor Screen, Gasket
1.
Remove muffl er cover (A).
2.
Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3.
Remove spark arrestor screen cover (B), screen holder (C), gasket
(D), and screen (E), from muffl er body.
4.
Clean carbon deposits from muffl er components.
5.
Replace screen if it is cracked, plugged, or has holes burned
through.
6.
Assemble components in reverse order.
G
T
RASS
RIMMER
O
PERATOR
E
/B
C
RUSH
UTTER
'
M
S
ANUAL
A
D
C
B
25
Advertisement
Table of Contents
