American DJ Accu Spot 575 User Instructions page 17

Accu Spot 575
2. Tap the UP button until "EDIT" is displayed, press ENTER.
3. Tap the UP button until "REC" is displayed.
4. The display shows "RE.XX", "XX" stands for the scene
number in the internal memory of where your scenes from the
controller will be stored.
5. Press the UP or DOWN button to select your desired scene
number.
6. Press ENTER to confirm, and the fixture will record the
scenes from the external controller.
7. Press MODE/ESC to return to the main menu.
RUN
With the function "RUN", you can run your pre-made
program. You can set the number of steps under Step (S-01
- S-48). You can edit the individual scenes under Edit.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed, press ENTER.
3. Tap the UP button until "RUN" is displayed, press ENTER.
4. Press the UP button, to select either "ON" or "OFF".
5. Select a mode, and press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
American DJ - www.americandj.com - Accu Spot 575 Instruction Manual Page 33
®
Editing Program Accu Spot 575
Editing procedure 1: Using the control board only.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed. Press ENTER.
3. The display will show "SCXX", the "X" again stands for the
scene number. For example, "SC01" is displayed, it means you
will be editing scene 1, press ENTER. You can change the
scene number by pressing the UP button.
4. Press ENTER, the display will show "C-X", the "X" again
stands for the channel number. If "C-01" is displayed, you will
be editing channel 1 of your selected scene, press ENTER. You
can change the channel number by pressing the UP button.
5. The display will show the DMX value for the channel that is
being edited. It will be displayed as "11XX", it stands for Channel
11 of the editing scene, the DMX value is "XX".
6. Adjust the DMX value by pressing the UP button, until you
get the expected effect for this channel.
7. Press ENTER to enter the editing of the other channels of the
scene.
8. Repeat steps 5-8, until you finish setting all the DMX values
for all the channels of this scene, each scene can have 15
channels maximum.
9. Once all the channels are completed, the display will flash
"TIME", this stands for the time needed to run this scene.
10. Press ENTER to edit the time needed, the display shows
"TXXX", "X" stands for the time needed to run this scene. For
example, "T002" means scene 1 needs 0.4 seconds to run,
"T015" means scene 1 needs 3 seconds to run.
11. Adjust the time needed by pressing the UP button.
12. Press ENTER to save the settings for the scene you are
editing, the display will change to the next scene automatically.
American DJ - www.americandj.com - Accu Spot 575 Instruction Manual Page 34
®
Editing Program