American DJ Accu Spot 575 User Instructions page 14

Accu Spot 575
address. First make sure all channels are set to the value of "0".
1. On your DMX controller set the DMX value of Channel 1 to
the value "7".
2. Now set the DMX value of Channel 2 to the value "7" to
adjust the starting address between 1 and 255. To adjust the
address between 256 and 511 set Channel 2 to the value "8" .
3. Set the DMX value of Channel 3 to your desired start-
ing address. This will take about 20 seconds before the unit
accepts the new DMX address.
EXAMPLE: So, if you want the address to be 57, you must first
set the address that is currently assingned to the unit. The pro-
ceed to set Channel 1s' value to "7", Channel 2s' value to "7",
and Channel 3s' value to "57".
2ND EXAMPLE: Again, if you want the address to be 420, you
must first set the address that is currently assingned to the unit.
If you want the set the address to 420, set Channel 1s' value to
"7", Channel 2s' value to "8", and Channel 3s to "164". (256 +
164 = 420)
DLOF
- With this function you can switch the lamp on via
DMX.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "DLOF" is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either "ON" to acti-
vate this function, or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
American DJ - www.americandj.com - Accu Spot 575 Instruction Manual Page 27
®
System Menu Accu Spot 575
DLAY
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "DLAY" is displayed, press ENTER.
4. The display should show "D-00". Press the UP button in
order to select your desired delay time.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
SPOT
the control board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "SPOT" is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either "ON" to acti-
vate this function, or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
DFSE
settings of the device. All settings will be set back to the
default values. Any edited scenes will be lost. When restor-
ing the factory settings the unit must be set to the address
that the unit was in when you started editing.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
American DJ
- With this function you can set a lamp delay time.
- With this function you can adjust the lamp via
- With this function you can restore the factory
- www.americandj.com - Accu Spot 575 Instruction Manual Page 28
®
System Menu