Grizzly H6186 Instruction Sheet

EyE/EAR INJURy HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 120 PSI!
Personal
occur.
SHATTERINg
Use
impact wrench use only.

Specifications

Drive Size .........................................................
No-Load Speed .................................. 9,500 RPM
Maximum Torque .................................... 190 ft/lb
Air Inlet Size .............................................
Air Consumption ..................................... 3.8 CFM
Operating Pressure ................................... 90 PSI
Maximum Operating Pressure ................. 120 PSI
Weight ........................................................3.3 lbs

Operation

Install any ⁄ " drive socket into your air impact
3
8
wrench. To change direction, push the valve
knob, shown in Figure 1, in or out. To adjust the
torue setting, turn the valve knob from 0 to 5.
Connect to air line regulated at 90 PSI.
WARNINg: NO PORTION OF THIS MANUAL MAy bE REPRODUCED IN ANy SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF gRIzzLy INDUSTRIAL, INC.
INJURy HAzARD!
injury could
HAzARD!
sockets rated
⁄ " NPT
1
4
COPyRIgHT © MAy, 2008 By gRIzzLy INDuSTRIAL, INC.
#JM10713 PRINTeD IN TAIWAN
⁄ " IMPACT WRENCH
3
8
INSTRUCTION SHEET
for
The impact wrench MuST be regularly lubricated
with 3-4 drops of air tool oil directly into the air fit-
ting before each use. For best results, we recom-
mend using an in line filter, lubricator, and regula-
/ "
3
tor, as shown in Figure 2.
8
Quick
Connector
Your
Tool
Quick
Coupler
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
MODEL H6186
Figure 1. Model H6186
Quick
Lubricator
Connector
Quick
Air Hose
Coupler
Figure 2
Installing your tool.
.
Valve Knob
Regulator
Air
Compressor
Filter