Grizzly H6187 Instruction Sheet

EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 150 PSI!
Personal
occur.
SHATTERING
Use
impact wrench use only.
Introduction
• Operates at 90 PSI
• 3.8 CFM air consumption
• 95 dB sound level
• 1/4" NPT air inlet
• 8000 RPM free speed
• 460 ft/lbs maximum torque
Inventory
A.
⁄ " Industrial Impact Wrench ...................... 1
1
2
Operation
Install ⁄ " drive socket onto your impact wrench.
1
2
Use only impact wrench sockets. Choose from
clockwise (F) to tighten, or counterclockwise (R)
to loosen by turning the direction switch (Ref #
41). Forward torque can be set from 1-3.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
INJURY HAZARD!
injury could
HAZARD!
sockets rated
COPYRIGHT © JUNE, 2006 BY GRIZZLY INDUSTRIAL, INC.
#PC8337 PRINTED IN TAIWAN
1
IMPACT WRENCH
INSTRUCTION SHEET
for
The impact wrench MUST have 3-4 drops of air
tool oil directly dropped into the air fitting before
each use. For best results, use the automatic
oiler setup shown in Figure 2. Fill the oil chamber
with SAE#30 oil before use. Then check every 48
hours of use and refill as needed.
Note: The oil chamber is independent of the air
chamber and will not be serviced by the automatic
oiler.
Quick
Connector
Your
Tool
Quick
Coupler
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
MODEL H6187
⁄ " INDUSTRIAL
2
Fill with SAE#30 Before Use
Figure 1. Model H6187
Quick
Lubricator
Connector
Quick
Air Hose
Filter
Coupler
Figure 2
Installing your tool.
.
Regulator
Air
Compressor