Grizzly H0583 Instruction Sheet

EYE/EAR INJURY HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 115 PSI!
Personal
occur..
SHATTERINg
Use
impact wrench use only..

Specifications

Drive Size .......................................................... 1"
Bolt Size Capacity .......................................... 1
No-Load Speed .................................. 3,000 RPM
Maximum Torque ................................. 1,400 ft/lb
Air Inlet Size .............................................
Air Consumption ...................................... 14 CFM
Operating Pressure ................................... 90 PSI
Maximum Operating Pressure ................. 115 PSI
Weight ......................................................28.6 lbs
Inventory
A.. Impact Wrench ........................................... 1
B.. Side Handle ................................................ 1
C.. Cap Screws ................................................ 4
Setup
Secure the side handle to the impact wrench with
the cap screws.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
WARNINg: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF gRIzzLY INDUSTRIAL, INC..
INJURY HAzARD!
injury could
HAzARD!
sockets rated
⁄ " NPT
1
2
COPyRIgHT © MAy, 2008 By gRIzzLy INDuSTRIAL, INC.
#JM10694 PRINTeD IN TAIWAN
IMPACT WRENCH
INSTRUCTION SHEET
for
Operation
Install any 1" drive socket into your air impact
wrench. Flip the forward/reverse switch, shown in
Figure 1, to change direction. Connect to air line
regulated at 90 PSI. using both hands, securely
⁄ "
3
hold onto the impact wrench and squeeze the
4
throttle.
Maintanence
The impact wrench MuST be regularly lubricated
with 3-4 drops of air tool oil directly into the air fit-
ting before each use. For best results, we recom-
mend using an in line filter, lubricator, and regula-
tor, as shown in Figure 2..
Quick
Connector
Your
Tool
Quick
Coupler
MODEL H0583
1" HEAVY–DUTY
TWO–HAMMER
Throttle
Side Handle
Forward/Reverse
Figure 1.. Model H0583
Quick
Lubricator
Connector
Quick
Air Hose
Coupler
Figure 2
Installing your tool.
..
Switch
Regulator
Air
Compressor
Filter