Section 4: Sanding; Supplies/Tools; Guitar Body - Grizzly H3122 Instruction Manual

Supplies/Tools

The majority of the wooden components in this kit
are fully machined from the factory and are ready
for assembly. A small amount of drilling, sanding
and light machining will need to be performed to
complete the guitar.
Recommended Tools & Supplies:
—Phillips Screwdriver
—Needle-Nose Pliers
—Electric Drill
—Drill Bit Set
—#180, #240, and #320 Aluminum-Oxide
Sanding Paper
—Sanding Block
—Masking Tape
—Painting/Finishing Supplies
—Coat Hanger
—C-Clamp
—Tack Cloth
—Coping, Jig, or Scroll Saw (Optional)
H3122 Classical Guitar Kit

SECTION 4: SANDING

Guitar Body

The guitar body has been assembled and rough
sanded at the factory; however, no finish has
been applied.
To sand the guitar body:
1. Wear an ANSI-approved respirator and
safety glasses when sanding wood!
2.
Using either an electric palm sander or a sand-
ing block, sand the guitar body (EXCEPT the
guitar neck notch, the edges, and the sound
hole) with #180 grit aluminum-oxide sand-
ing paper until there is a consistent scratch
pattern on the entire surface. Note—When
hand sanding, always sand in the same
direction as the wood grain.
3.
Sand the guitar body with a #240 grit sanding
paper until there is a consistent scratch pat-
tern on the entire surface.
4. Sand the guitar body with a #320 grit sanding
paper until there is a consistent scratch pat-
tern on the entire surface.
5.
Wipe the guitar body with a damp cloth.
Wiping the workpiece with a damp cloth
before the final sanding helps to "raise" the
wood grain; thus, allowing the "raised" grain
to be sanded smooth.
6. Once the guitar body is dry, repeat step 4.
7. Wipe the guitar body with a tack cloth to
remove all remaining sanding dust.
-5-