Table And Handwheel; Guard; Handwheel Handles - Grizzly G5963 Instruction Manual

Grizzly 6" x 12" surface grinder instruction manual model g5963
Hide thumbs Also See for G5963:
Table of Contents

Advertisement

Table and Handwheel

Wipe the V-grooves of the table and the saddle
down with way oil (Mobil Vactra #2 or equivalent).
The table rests by its own weight on the ways,
and is oiled by the lubrication system. Set the
sliding table in position on the saddle. Make sure
the gear on the underside of the table engages
with the gear on the handwheel shaft.
Thread the three spokes of the handwheel onto
the hub, and tighten the jam nuts. Turn the hand-
wheel back and forth to make sure the table
moves freely.
The table dogs should be in position to stop the
left and right movement of the table. Test these to
make sure the travel is limited so there is no
chance of moving the table too far in one direc-
tion. See Figure 4.
Figure 4. Table dogs limit table travel.
G5963 Surface Grinder

Guard

Attach the Guard to the left hand side of the table
using the socket head cap screws provided. This
guard helps to contain debris coming off the
rotating wheel during the grinding operation.

Handwheel Handles

There are two handwheels which control cross
feed and vertical movement. The handles for
these handwheels need to be threaded in the
hole in the outer edge of the wheel face.
-11-

Advertisement

Table of Contents
loading

Table of Contents