Table of Contents
Advertisement
MAINTENANCE
WARNING
REMOVING THE DOOR
To remove the door:
1.
Open the door fully.
2.
Lift the catches and push them forwards as far as they will go (fig. 1).
3.
Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (fig. 2).
To refit the door:
1.
Insert the hinges in their seats.
2.
Open the door fully.
3.
Lower the two catches.
4.
Close the door.
Fig. 1
Fig. 2
MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY)
1.
Remove the side accessory holder grilles (Fig. 3).
2.
Pull the heating element out a little (Fig. 4) and lower it (Fig. 5).
3.
To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral
supports.
Fig. 3
Fig. 4
REPLACING THE OVEN LAMP
To replace the rear lamp (if present):
1.
Disconnect the oven from the power supply.
2.
Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on.
3.
Reconnect the oven to the power supply.
To replace the side lamp (if present):
1.
Disconnect the oven from the power supply.
2.
Remove the side accessory holder grilles, if present (Fig. 3).
3.
Use a screwdriver to prise off the lamp cover (Fig. 7).
4.
Replace the lamp (see note for lamp type) (Fig. 8).
5.
Reposition the lamp cover, pushing it on firmly until it snaps into place (Fig. 9).
6.
Refit the side accessory holder grilles.
7.
Reconnect the oven to the power supply.
-
Use safety gloves.
-
Ensure the oven is cold before carrying out the following operations.
-
Disconnect the oven from the power supply.
Fig. 5
EN86
Advertisement
Table of Contents
