Table of Contents
Advertisement
Step 4
Push the grommet nuts into the pre-drilled
holes in the system base. Use the illustration
at the right to ensure the correct holes are
used. Position the pump on the base and
connect the union nut on the interconnect
pipe to the pump discharge and hand tighten
only. Install the supplied pump bolts into the
grommet nuts to secure the pump to the base.
TIP: Do not fully tighten pump bolts until
system set-up is complete.
NOTE: Some systems come with grommet
nuts, or equivalent, factory installed.
Step 5
Be certain that the filter cover is pushed
completely down and the Ring-Lok nut is
tightened to the "built-in stops" and yellow
safety latch is engaged.
If the Ring-Lok nut is not
tightened so yellow safety
latch is engaged, the filter
cover may blow off causing
injury or property damage.
Step 6
Carefully install the pressure gauge into the
filter cover after wrapping the brass threads
with 4 wraps of teflon tape (Note: Some
gauges have teflon tape factory installed.)
TIP: Install pressure gauge only hand tight
plus 1/4 turn.
Setting up your system:
5
Hide quick links:
Advertisement
Table of Contents
