Alfa Romeo 166 Booklet page 168

WARNING
Any work on the front
light units should be car-
ried out with the light switch at
position 0 (lights off) and with the
ignition key removed from the
switch: danger of electric dis-
charge.
To replace the bulb (Type D – D1,
35W):
– Remove the engine compartment cov-
er after turning the fastening pins.
– Remove the rubber cap (A-fig. 26)
by pulling the tab (B).
fig. 26
168
– Release the clip (C- fig. 27).
– Remove the bulb (D- fig. 28) and
disconnect the snap-fitted connector (E).
Xenon bulbs may only
be touched on the metal
part. If the glass bulb is
touched by the fingers, clean it
carefully with a clean cloth
moistened with methylated spirit
and allow to dry before refitting
the bulb.
fig. 27
– Fit connector to new bulb.
– Fit the bulb in the headlight reflector
making the notch coincide with the corre-
sponding groove.
– Lock the bulb with the clip.
– Fit the rubber cap.
– Refit the engine compartment cover
and fasten turning the fastening pins.
fig. 28