Important Safety Instructions - Imperial Winchester Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS:

READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
When installing and using this electrical equipment, basic safety precau-
tions should always be followed, including:
1) WARNING: To reduce the risk of injury, do not permit children to use
this product unless they are closely supervised at all times.
2) WARNING: A grounding wire connector is provided on this unit to
connect a minimum No. 8AWG (8.4mm
between this unit and any metal equipment, metal enclosures of
electrical equipment, metal water pipe, or conduit within 5 feet (1.5m)
of the unit.
3) DANGER: Risk of Accidental Drowning. Extreme caution must be
exercised to prevent unauthorized access by children. To avoid acci-
dents, ensure that children cannot use this hot tub unless they are
supervised at all times.
4) DANGER: Risk of Injury. The suction fittings in this hot tub are sized
to match the specific water flow created by the pump. Should the
need arise to replace the suction fittings or the pump, be sure that
the flow rates are compatible. Never operate the hot tub if the suction
fittings are broken or missing. Never replace a suction fitting with one
rated less than the flow rate marked on the original suction fitting.
5) DANGER: Risk of Electric Shock. Install at least 5 feet (1.5m), from
all metal surfaces. As an alternative, a hot tub may be installed within
5 feet (1.5m) of metal surfaces if each metal surface is permanently
connected (bonded) by a minimum No. 8 AWG (8.4 mm
per conductor attached to the wire connector on the grounding lug,
inside the equipment compartment on the equipment box.
6) DANGER: Risk of Electric Shock. Do not permit any electrical appli-
ance, such as a light, telephone, radio, television, etc. within 5 feet
(1.5m) of a hot tub.
7) ELECTRICAL SUPPLY: The electrical supply for this product must
include a suitably rated switch or circuit breaker to open all unground-
ed supply conductors to comply with section 422-20 of the National
Electrical Code, ANSI/NFPA 70. The disconnect must be readily
accessible and visible to the hot tub occupant but installed at least 5
Page 6
2
) solid copper conductor
2
) solid cop-