Imperial Winchester Owner's Manual page 14

• Fill the hot tub until the water level is above all jets. Warning: Do not
over-fill.
• Remove the hose and replace the filter cartridge.
3. TURN ON THE POWER
Turn on the power to the hot tub at the home's circuit breaker. The
heater and the pump's low speed automatically activate and the LED
display on the control panel shows the water temperature.
4. ACTIVATE JETS
Press the JETS or JETS 1 button on the control panel once to activate
pump 1 in low speed. Press the button a second time to activate pump
1 in high speed and initiate maximum water flow to certain jets.
5. ADD START-UP CHEMICALS
Add the hot tub water chemicals (Contact Jacuzzi Spa Division for any
assistance or questions). (See the section titled MAINTAINING WATER
QUALITY (page 23) for general guidance.)
6. SET HOT TUB TO HEAT (Default Set Temp is 100˚F (38˚C))
To warm the hot tub water up to a comfortable temperature, follow these
steps:
• The LED display on the control panel displays the actual temperature
of the hot tub water. Press either the COOLER (Down) or WARMER
(Up) button to display the "set" temperature for 5 seconds. If you
want the water to heat to a different temperature, simply press
COOLER or WARMER within 5 seconds while the "set" temperature
is displayed. The set temperature advances or decreases by one
degree each time one of these sensor pads is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
NOTE:
• The maximum temperature for which the hot tub can be set is 104˚F (40˚C)
and the minimum is 65˚F (18˚C).
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
7. PLACE COVER ON HOT TUB
• Keeping the insulating cover in place anytime the hot tub is not in use
will reduce the time required for heating, thereby minimizing operat-
ing costs.
Page 15