Economy Mode; Care And Maintenance Of Your Hot Tub; Cleaning The Filters - Imperial Winchester Owner's Manual

NOTE: The initial time still operates the filter cycle in this mode to
ensure proper filtration.
F1 2 hours of filtration every 12 hours
F2 2 hours of filtration every 8 hours
F3 2 hours of filtration every 6 hours

ECONOMY MODE

In this mode, the timer determines when the filtering and heating take
place.
F4 2 hours of filtration every 12 hours
F5 2 hours of filtration every 8 hours
F6 2 hours of filtration every 6 hours
L1 LOCKOUT - special feature used when cleaning or changing the
filter cartridge or any type of non-electrical servicing that requires the hot
tub's pump operation to be suspended while the work is completed. The
temperature readout flashes in this function.
NOTE: If the hot tub is heating when the system is put into the lock-
out mode, the heater will immediately turn off and the pump will cycle
water for thirty seconds, then turn off. This will assist in cooling the
heater element.
L2 LOCK MODE - Special feature to prevent unauthorized use of your
hot tub which disables Jets and Light buttons. Your filter cycles and heat-
ing will continue to operate normally. The temperature readout flashes in
this function.

Care and Maintenance of Your Hot Tub

Proper and regular maintenance of your hot tub will help it retain its beau-
ty and performance. Contact Jacuzzi Spa Division for any assistance or
questions.
CLEANING THE FILTER
Your hot tub is equipped with a cartridge filters located in the skimmer/
filter well. Filtering is accomplished when the 2-speed pump 1, on
either high or low speed, causes water to flow through the polyester
mesh of the filters. As this happens, suspended particles become
trapped on the filter's surface.
Page 19