Troubleshooting Procedures; Problem - Procedure; Pump Priming Instructions - Imperial Winchester Owner's Manual

In the unlikely event your hot tub is not working the way you believe it
should, please first review all the installation and operating instructions in
this manual and check the message on the panel display; second, if you
are still not satisfied it is working properly, please follow the appropriate
troubleshooting instructions.
PROBLEM
NONE OF THE
COMPONENTS
OPERATE
(i.e. pump, light)
PUMP DOES NOT Depress "Jets" sensor.
OPERATE BUT
LIGHT DOES
OPERATE.
Pump Priming Instructions: Turn Hot Tub Off!
Remove filter and insert end of garden hose into filter pipe. Seal-off
pipe opening around hose using a large, clean rag and turn on maxi-
mum water flow through the hose. After about 30 seconds, turn off
water, remove hose and rag, reinstall filter and activate pump's high
speed.
IMPORTANT: If freezing conditions exist and pump is not opera-
tional, take measures to protect the system from freeze damage.
See "Winterizing", page 22.
POOR JET ACTION
WATER IS TOO HOT
Page 26

Troubleshooting Procedures

PROCEDURE
Check the control panel lights.
1. If there are letters or symbols displayed on the
screen, refer to the previous section to
determine meaning and action required.
2. If nothing appears on the screen:
a. Check the household circuit breaker.
b. Contact Jacuzzi Spa Division
1. If no sound is detected or if a "buzzing" sound is
detected, turn off power to hot tub and contact
Jacuzzi Spa Division.
2. If motor operates but no water flows to jets:
a. Pump may not be properly primed. See
instructions on the next page.
b. Contact Jacuzzi Spa Division.
1. Make certain the pump is on high speed.
2. Make sure jets are fully open.
3. Open air control for the jet system selected.
4. Check for adequate water level.
5. Check for dirty filter.
1. Reduce thermostat setting.
2. Reduce filtration cycle length. (Even without
heater on, water temperature can increase
from prolonged pump operation.)