Setting-Up Projector; Connecting Ac Power Cord - Panasonic PLC-XP40 Owner's Manual

PREPARATION
This projector uses nominal input voltages of 100-120 V or 200-240
V AC. This projector automatically selects correct input voltage. It
is designed to work with single-phase power systems having a
grounded neutral conductor. To reduce risk of electrical shock, do
not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of type of power supply being in use.
Connect a projector with a peripheral equipment before turning a
projector on. (Refer to pages 11 ~ 13 for connection.)
CAUTION
For safety, unplug AC Power Cord when an appliance is not
used.
When this projector is connected to outlet with AC Power Cord,
an appliance is in Stand-by Mode and consumes a little electric
power.
NOTE ON POWER CORD
AC Power Cord must meet requirement of country where you use a projector.
Confirm an AC plug type with chart below and proper AC Power Cord must be used.
If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on your
projector.
8

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect AC Power Cord (supplied) to a projector.
AC outlet must be near this equipment and must
be easily accessible.
AC Outlet side
For Continental Europe
To the AC Outlet.
(200 - 240 V AC)
For the U.K.
To the AC Outlet.
(200 - 240 V AC)