Panasonic PLC-XP40 Owner's Manual page 36

SETTING
Power management
This function turns Projection Lamp off when this projector detects
signal interruption and is not used for a certain period in order to
reduce power consumption and maintain Lamp-life. (This projector is
shipped with this function ON.)
Power Management function operates to turn Projection Lamp off
when input signal is interrupted and any button is not pressed over 5
minutes. This function operates as follows;
1. When any input signal is interrupted, "No signal" and counting
down display appears (for 5 minutes).
2. After counting down for 5 minutes, projector lamp and READY
indicator are turned off.
3. When READY indicator flashing, Projection Lamp can be
turned on again (Power Management mode).
In this Power Management mode, Projection Lamp is
automatically turned on when input signal connected or
projector is operated with any button on Top Control or on
Remote Control Unit again.
On start
When this function is "On," projector is automatically turned on just
by connecting AC Power cord to a wall outlet.
Note ; Be sure to turn projector off properly (refer to section
"TURNING OFF PROJECTOR" on P19). If projector is turned
off in wrong steps, On Start function does not operate
properly.
Remote control
This projector has two different remote control codes; factory-set
normal code (Code 1) and secondary code (Code 2). This switching
function prevents remote control operation mixture (jam) when
operating several projectors or video equipment together.
When operating projector in "Code 2," both projector and Remote
Control Unit must be switched to "Code 2."
To change code of Projector;
Set Remote control in SETTING MENU to "Code 2."
To change code of Remote Control Unit;
Press both MENU and IMAGE buttons on Remote Control Unit
together for over 10 seconds.
After changing code, make sure Remote Control operates properly.
To return to normal code (Code 1), operate both projector and
Remote Control in ways above again.
NOTE : When batteries of Remote Control Unit are replaced or ALL-
OFF switch is turned to "ALL-OFF," remote transmit code
automatically returns to normal code (Code 1).
Lamp counter reset
This function is used to reset Lamp Replace Counter. When
replacing Projection Lamp, reset Lamp Replace Counter by using
this function. Refer to page 39 for operation.
36
Time left until Lamp off.
Press SELECT button at this icon to
display other items.
On start
Press SELECT button at this icon to
display previous items.
Move pointer to item and then press
POINT LEFT/RIGHT button(s).
Move pointer to Lamp counter reset and then press
SELECT button. Message "Lamp replace counter
reset?" is displayed.