Table of Contents
Advertisement
Changing The Battery
CAUTION: To reduce the risk of fire or personal injury, use only the Telefield NA
Inc. approved Nickel-metal Hydride (Ni-MH) battery model T-T104, which is
compatible with this unit.
1. Make sure the telephone is in standby mode (not in TALK mode) before you replace bat-
tery.
2. Remove the battery compartment door.
3. Disconnect the cord attached to the battery pack and remove the battery pack from the
handset.
4. Insert the new battery pack and connect the cord to the jack inside the battery compart-
ment.
5. Put the battery compartment door back on.
6. Place handset in the base or handset charge cradle to charge. Allow the handset battery
to properly charge (for 14 hours) prior to first use or when you install a new battery pack. If
you do not properly charge the phone, battery performance may be compromised.
Display Messages
The following messages show the status of the phone, provides Caller ID information, or
helps you set up and use your phone.
BLOCKED
DELETE ALL?
DELETE?
ENTER NAME
ENTER NUMBER
NEW CALLS
HANDSET NAME
UNAVAILABLE
NO LINE
LINE IN USE
EMPTY
SEARCHING
PAGE FROM BASE Someone pressed the PAGE button on the base.
UNKNOWN
26
Indicates the person is calling from a number which is blocked from
transmission.
Prompt asking if you want to erase all records.
Prompt asking if you want to erase the current record.
Prompt telling you to enter a name.
Prompt telling you to enter a telephone number.
Indicates call or calls which have not been reviewed.
Prompt telling you to enter a user name for the handset.
The handset is not yet registered or is out of range.
Indicates that the telephone line is not connected.
Display on handset while the line is in use.
Indicates there are no CID records in memory.
Indicates handset is too far away from the base, and the handset is
searching for the base.
Indicates incoming call is from an area not serviced by CID or the CID
information was not sent.
Advertisement
Table of Contents
