NetComm VELOCITY NP805N User Manual page 44

Velocity series gigabit wireless router

Hide thumbs Also See for VELOCITY NP805N:

Table of Contents

Routing

Routing tables allow you to determine which physical interface address to use for outgoing IP data. If you have more than one

router and subnet, you will need to configure the routing table to allow packets to find the proper routing path and allow different

subnets to communicate with each other.

These settings are used to setup the static and dynamic routing features of the NP805N.

Dynamic Routing:

Routing Information Protocol (RIP) will exchange information about different host destinations for working out routes throughout the

network.

Please note: Only select RIPv2 if you have a different subnet in your network. Otherwise, please select RIPv1.

Static Routing:

For static routing, you can specify up to 8 routing rules.

You need to enter the destination IP address, subnet mask, gateway, and hop for each routing rule, then enable the rule by clicking

the Enable checkbox.

Click on "Save" to store your setting or "Undo" to discard your changes.

YMLO-805N

www.netcomm.com.au

NP805N – Gigabit Wireless Router

NetComm NP805N - Gigabit Wireless Router

Table of Contents